i2cperipheral – Two wire serial protocol peripheral¶
i2cperipheral module contains classes to support an I2C peripheral.
Example emulating a peripheral with 2 addresses (read and write):
import board from i2cperipheral import I2CPeripheral regs =  * 16 index = 0 with I2CPeripheral(board.SCL, board.SDA, (0x40, 0x41)) as device: while True: r = device.request() if not r: # Maybe do some housekeeping continue with r: # Closes the transfer if necessary by sending a NACK or feeding dummy bytes if r.address == 0x40: if not r.is_read: # Main write which is Selected read b = r.read(1) if not b or b > 15: break index = b b = r.read(1) if b: regs[index] = b elif r.is_restart: # Combined transfer: This is the Main read message n = r.write(bytes([regs[index]])) #else: # A read transfer is not supported in this example # If the microcontroller tries, it will get 0xff byte(s) by the ctx manager (r.close()) elif r.address == 0x41: if not r.is_read: b = r.read(1) if b and b == 0xde: # do something pass
This example sets up an I2C device that can be accessed from Linux like this:
$ i2cget -y 1 0x40 0x01 0x00 $ i2cset -y 1 0x40 0x01 0xaa $ i2cget -y 1 0x40 0x01 0xaa
I2CPeripheral makes use of clock stretching in order to slow down the host. Make sure the I2C host supports this.
Raspberry Pi in particular does not support this with its I2C hw block.
This can be worked around by using the
i2c-gpio bit banging driver.
Since the RPi firmware uses the hw i2c, it’s not possible to emulate a HAT eeprom.
I2CPeripheral(scl: microcontroller.Pin, sda: microcontroller.Pin, addresses: Sequence[int], smbus: bool = False)¶
Two wire serial protocol peripheral
I2C is a two-wire protocol for communicating between devices. This implements the peripheral (sensor, secondary) side.
__exit__(self) → None¶
Automatically deinitializes the hardware on context exit. See Lifetime and ContextManagers for more info.
I2CPeripheralRequest(peripheral: I2CPeripheral, address: int, is_read: bool, is_restart: bool)¶
Information about an I2C transfer request This cannot be instantiated directly, but is returned by
peripheral – The I2CPeripheral object receiving this request
address – I2C address
is_read – True if the main peripheral is requesting data
is_restart – Repeated Start Condition
The I2C address of the request.
The I2C main controller is reading from this peripheral.
Is Repeated Start Condition.
read(self, n: int = - 1, ack: bool = True) → bytearray¶
Read data. If ack=False, the caller is responsible for calling
n – Number of bytes to read (negative means all)
ack – Whether or not to send an ACK after the n’th byte
write(self, buffer: _typing.ReadableBuffer) → int¶
Write the data contained in buffer.
buffer (ReadableBuffer) – Write out the data in this buffer
Number of bytes written