CircuitPython Port To The Nordic Semiconductor nRF52 Series¶
This is a port of CircuitPython to the Nordic Semiconductor nRF52 series of chips.
NOTE: There are board-specific READMEs that may be more up to date than the generic board-neutral documentation below.
Some boards have UF2 bootloaders and can simply be flashed in the normal way, by copying firmware.uf2 to the BOOT drive.
For some boards, you can use the
make BOARD=pca10056 flash
Install the necessary tools to flash and debug using Segger:
note: On Linux it might be required to link SEGGER’s
libjlinkarm.so inside nrfjprog’s folder.
run follow command to install adafruit-nrfutil from PyPi
$ pip3 install --user adafruit-nrfutil
make flash and make sd will not work with DFU targets. Hence, dfu-gen and dfu-flash must be used instead.
dfu-gen: Generates a Firmware zip to be used by the DFU flash application.
dfu-flash: Triggers the DFU flash application to upload the firmware from the generated Firmware zip file.
When enabled you have different options to test it: