Simple test

Ensure your device works with this simple test.

examples/tlc5947_simpletest.py
 1
 2
 3
 4
 5
 6
 7
 8
 9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
# Simple demo of controlling the TLC5947 12-bit 24-channel PWM controller.
# Will update channel values to different PWM duty cycles.
# Author: Tony DiCola

import board
import busio
import digitalio

import adafruit_tlc5947

# Define pins connected to the TLC5947
SCK = board.SCK
MOSI = board.MOSI
LATCH = digitalio.DigitalInOut(board.D5)

# Initialize SPI bus.
spi = busio.SPI(clock=SCK, MOSI=MOSI)

# Initialize TLC5947
tlc5947 = adafruit_tlc5947.TLC5947(spi, LATCH)
# You can optionally disable auto_write which allows you to control when
# channel state is written to the chip.  Normally auto_write is true and
# will automatically write out changes as soon as they happen to a channel, but
# if you need more control or atomic updates of multiple channels then disable
# and manually call write as shown below.
#tlc5947 = adafruit_tlc5947.TLC5947(spi, LATCH, auto_write=False)

# There are two ways to channel channel PWM values.  The first is by getting
# a PWMOut object that acts like the built-in PWMOut and can be used anywhere
# it is used in your code.  Change the duty_cycle property to a 16-bit value
# (note this is NOT the 12-bit value supported by the chip natively) and the
# PWM channel will be updated.

# With an RGB LED hooked up to pins 0, 1, and 2, cycle the red, green, and
# blue pins up and down:

red = tlc5947.create_pwm_out(0)
green = tlc5947.create_pwm_out(1)
blue = tlc5947.create_pwm_out(2)

step = 10
start_pwm = 0
end_pwm = 32767 # 50% (32767, or half of the maximum 65535):

while True:
    for pin in (red, green, blue):
        # Brighten:
        print("Brightening LED")
        for pwm in range(start_pwm, end_pwm, step):
            pin.duty_cycle = pwm

        # Dim:
        print("Dimming LED")
        for pwm in range(end_pwm, start_pwm, 0 - step):
            pin.duty_cycle = pwm

# Note if auto_write was disabled you need to call write on the parent to
# make sure the value is written (this is not common, if disabling auto_write
# you probably want to use the direct 12-bit raw access instead shown below).
# tlc5947.write()

# The other way to read and write channels is directly with each channel 12-bit
# value and an item accessor syntax.  Index into the TLC5947 with the channel
# number (0-23) and get or set its 12-bit value (0-4095).
# For example set channel 1 to 50% duty cycle.
# tlc5947[1] = 2048
# Again be sure to call write if you disabled auto_write.
#tlc5947.write()